How Do I Change A Kitchen Faucet

How to Supercede a Kitchen Faucet

Kitchen faucets are probably one of the most used fixtures in homes. Many times a day the h2o is turned on and off, leading to quite a bit of wear and tear on this hardworking fixture. If your faucet has seen meliorate days, or is out of way, you can supersede information technology with a shiny new version using just a few tools. Exchanging your old kitchen faucet with a new one can transform the await and functionality of your kitchen in but a couple of hours.

Tools yous'll Need

Have all the necessary tools for this DIY projection lined up earlier y'all start to relieve yourself fourth dimension and frustration.

New Faucet
Aqueduct locking pliers
Basin wrench
Plumber'due south Putty
Adaptable Wrench
Flexible supply lines
Tape Measure

Before Starting

Plow off the hot and cold water shut-off valves. they're ordinarily located in the cabinet that'south nether the sink. Then open up the faucet to relieve pressure level.

Removing the Old Faucet

Stride One: Using an adaptable wrench and a pair of channel locking pliers, disconnect both the water lines from the faucet. If the supply lines are old, or the gaskets are worn out, yous may want to replace them with flexible supply lines.
Footstep Ii: Using a socket wrench or basin wrench remove the nut that is holding the faucet tailpiece associates in identify. Sometimes it's difficult to loosen quondam faucet basics, in that case effort soaking the threads with penetrating oil and effort over again.
Step Three: If your sink has a line that connects the hose to the faucet you tin can disconnect this.
Step Four: Pull the old faucet out and make clean the sink's surface making sure to remove any rust or caked on debris.

Installing the New Faucet

Step One: Using the measuring record, measure the distance, from center to center, of the outside holes of your sink. This is to make sure the new faucet volition fit. Since all faucets are slightly different, read any installation instructions that come with your new faucet. Follow all manufacturer'due south pre-assembly instructions and place the optional flange over the faucet opening.
Step Two: Seal the new faucet. If you're using a gasket, identify the gasket on the lip of the plate and thread the hoses through. If using plumber'southward putty, apply it around the base of the faucet and gear up the faucet in place.
Stride 3: Under the sink you can now thread on the flange and nut using a socket or basin wrench.
Step Four: If yous're using pull-out faucets, a weight needs to exist added that will retract the pull-out spray.
Step Five: Now information technology's time to attach the supply lines to the faucet and so to the shut-off valves. Cold water connects on the right and hot water on the left.
Pace Six: Plow on the water and check for leaking. If you find whatever leaks you lot'll need to tighten the connections on the water supply line.